Stop the Engine

IMPORTANT: Before stopping an engine that has been operating at working load, idle engine at least 2 minutes at 1000—1200 rpm to cool hot engine parts. If an Exhaust Filter Cleaning has just been performed, increase engine idle time to 4 minutes. If service work is going to be performed on exhaust filter, increase engine idle time to 10 minutes.

IMPORTANT: Final Tier 4 and Stage IV Engines only: To determine tractor engine type, see Record Engine Serial Number in Identification Numbers section of this Operator's Manual. Do not disconnect battery until Selective Catalytic Reduction (SCR) system has had enough time to automatically purge system of Diesel Exhaust Fluid (DEF). If adequate time is not allowed for system to be purged, any DEF remaining can crystallize and plug system. At temperatures below -15°C (5°F), unpurged DEF will freeze and damage system components. If equipped with a battery disconnect system, a light next to disconnect system is illuminated while auto-purge is in progress. It shuts off when complete and safe to disconnect the battery.

If tractor is not equipped with battery disconnect switch, wait at least 4 minutes after tractor stops before disconnecting battery.

1. Stop tractor and pull throttle back to slow idle position.

2. Depress clutch and brake pedals.

3. Put transmission in PARK position.

4. Lower all equipment to the ground.

5. Make sure SCV levers are in NEUTRAL position.

6. Pull rear PTO (if equipped) switch rearward to disengage PTO.

7. CAUTION: Remove ignition switch key to prevent accidents.

   Turn key switch to OFF position and remove key.