Powershift Transmission Requirements

Before transferring control to the implement, perform all necessary steps to prepare the implement as indicated in implement operator’s manual. Transfer control using AutoTrac™ resume switch or TIA™ resume button as presented in Operating Tractor Implement Automation section of this Operator’s Manual.

• Implement can accelerate tractor up to set speed limit set by operator. Implement limit is determined by maximum speed setting and set speed adjusting wheel. This operator-set limit set cannot be exceeded by implement.

To transfer control to the implement, the following preconditions have to be met:

• Operator sitting on seat.
• No transmission malfunctions detected.
• Shift lever in Forward.

NOTE: When transferring control to the implement, Efficiency Manager™ mode will engage.

To withdraw control using the shift lever:

• During driving: Shift up or down manually.
• Increasing the speed will end the Auto Mode. The implement has all information to inform the operator that this intervention will end the travel speed Auto Mode (see implement Operator's Manual).

NOTE: Reducing the speed is always allowed.

It is allowed to increase the limit set by the operator within 2 seconds after starting the travel speed Auto Mode.

The current travel speed can be limited by other processes (e.g. iTEC™). This limit will be observed, however, it will not be considered as an intervention by the operator.