Implement Guidelines

Front-Mounted Implements:

Front frame reinforcement is recommended whenever tractor has front-mounted dozer blades or spray tanks, is used in scraper applications, or is equipped with front frame ballast.

Reinforcement attaches to underside of front axle and to outside of front frame behind front axle. See your John Deere™ Dealer for parts and assistance.

Towed Scrapers:

IMPORTANT: Under scraper or severe applications, tighten wheel bolts every 2 HOURS until all cap screws remain at 600 N·m (445 lb·ft).

Follow manufacturers instruction in attaching and using scraper.

NON-APPROVED USES
Spray Tanks - Mounted forward of grille screen
Spray Tanks - Unbalanced
Scrapers - Without proper tractor/scraper drawbar and frame/axle supports (9470R, 9520R, 9570R and 9620R)
Tiling Plows - Are not approved
Fully Mounted Hitch Implements - Center of gravity greater than 609 mm (24 in) beyond hitch points
Fully Mounted Hitch Implements - Total weight exceeds 6350 kg (14000 lb) - Category 4 (Without additional implement mounted lift-assist)
Fully Mounted Hitch Implements - Total weight exceeds 6123 kg (13500 lb) - Category 3 (Without additional implement mounted lift-assist)
9470R, 9520R, 9570R and 9620R with Category 3 Hitch - Deep ripping/plowing applications using full horsepower (Use Category 4 hitch)
Extreme Draft Loads - Requiring two tractors hooked in tandem
Tow Hooks - Adding tow hooks is not an option