Powershift Transmission Requirements

Before transferring control to implement, prepare implement as indicated in implement operator’s manual. Transfer control using AutoTrac™ resume button as presented in the implement operator’s manual.

The implement cannot exceed ground speed set by the operator.

Following conditions must be met before transferring control to implement:

• Operator in seat.
• No malfunctions present in transmission.
• Shift lever in forward.

When transferring control to the implement, Efficiency Manager™ mode will engage.

Speed may always be reduced.

Set speed limit may be increased within 2 seconds after engaging travel speed auto mode. Current travel speed can be limited by other processes (e.g. iTEC™). This limit will be observed; however, the limit will not be considered as an intervention by operator.

To disengage control using the shift lever:

• During driving: Shift up or down manually.
• Increasing the speed will end the auto mode. The implement has all information to inform the operator that this intervention will end the travel speed auto mode. See implement operator's manual.