Service Sections Overview

Avoid personal injury. After completing any service procedure, reinstall any shields or covers that have been removed and close and securely latch hood.

This publication is not a detailed service manual. Procedures shown cover routine maintenance and service. For more detailed service information, purchase a Technical Manual through your John Deere dealer.

Recommended service intervals are for average conditions. Service more often if tractor is operated under adverse conditions.

Service sections provide information on service processes and procedures.

Fuel, Lubrication, and Coolants Sections: Information on approved fluids for operation and service. Also included are guides to selection of correct service intervals for such procedures as engine oil refill.

Break-In Service: Perform listed services during first 100 hours of operation.

Engine Oil and Filter Change: Acceptable engine oils based on emissions configuration of tractor engine. Indicate which oil was used for refill and complete data block at each service.

Annual Service: Services listed are performed annually or at some multiple of years. Complete service and data block.

As Required Service: Complete records for services and repairs that are performed at other than regular service intervals.

Daily or 10 Hour and 50 Hour Services: Perform these services every day or every 10 hours and every 50 hours. Forms do not include check boxes. All services listed for these intervals are included on hourly service interval charts.

Hourly Interval Services: Charts are provided based on standard service intervals. Tasks on charts match organization of service procedure sections (example: Service – Clean). Individual service procedures are grouped within these sections (example: Dual Beam Radar Sensor).

When listed operating hours have elapsed, stop tractor as soon as practical and complete all listed services. Check off services as completed.

Engine hour meter can be used to signal time to perform these services. Meter operates whenever engine is running and shows actual accumulated hours of engine operation. Engine hour meter is factory set to 250 hours, but can be reset to any desired elapsed time. See Service Intervals in CommandCenter™ section of this Operator’s Manual.

Master charts are provided for service interval of up to 6000 hours. An additional set of charts allow recording services beyond 6000 hours.

Service Procedure Sections: Various scheduled and unscheduled service procedures are organized by procedure type within six sections. Appropriate Service sections and task names are referenced in Service Record Charts (example: Change: Engine Oil and Filter). Electrical section includes all service information for lighting, fuses, and relays.

Troubleshooting Sections: Procedural troubleshooting is provided, as well as information on dealing with Diagnostic Trouble Codes (DTCs) that may display on the CommandCenter™ .