Change Transmission-Hydraulic Oil and Filter

1. Lower rockshaft to remove trapped oil.

NOTE: The approximate transmission case oil capacity is 33 L (8.7 gal).

2. Remove drain plug (A) from transmission case and drain oil. Dispose of waste oil properly.

3. If equipped with MFWD axle, also remove drain plug (B) in drop housing.

4. Replace filter (C) while changing oil. Apply a film of oil to new filter gasket and install new filter. Hand tighten only.


A-Transmission Case Drain Plug
B-MFWD Drop Housing Drain Plug-If Equipped
C-Oil Filter

LV4220
LV4221
LV4222

AG,OUO1032,2565 -19-21AUG99-1/2

5. Fill system with transmission-hydraulic oil. (See Fuels, Lubricants and Coolant section.)

Specification

Transmission Oil -Capacity 33 L (8.7 gal)

6. Check oil level at sight glass after filling. Make sure oil level is to full level mark (A). Check again after operating for five minutes. Add oil if necessary.


A-Full Level Mark
B-Add Level Mark

LV4194

AG,OUO1032,2565 -19-21AUG99-2/2