Adjusting Drawbar Length

Lift drawbar pin retaining latch (A). Remove drawbar pin (B). Slide drawbar to desired position. Install drawbar pin and rotate latch to secure drawbar pin.

The drawbar can be locked in the center position by using drawbar cap screws (C). It can also be locked to either side by using one drawbar cap screw in the center hole.

Drawbar cap screws (C) can be removed to let drawbar swing free. This is helpful when turning under load. There are two holes on either side of the pivot for cap screw storage.

A-Drawbar Pin Retaining Latch
B-Drawbar Pin
C-Drawbar Cap Screw (2 used)

AG,OUO1043,202 -19-08JUN00-1/1