| Item |
Daily or 10 Hours |
Weekly or 50 Hours |
First 100 Hours |
First 300 Hours |
Every 300 Hours |
Every 500 Hours |
| Check Engine Oil Level |
· |
|
|
|
|
|
| Drain Water and Sediment from Fuel Filter a |
· |
|
|
|
|
|
| Check Coolant Level |
|
· |
|
|
|
|
| Check Transmission-Hydraulic System Oil Level |
|
· |
|
|
|
|
| Look for Oil Leak at MFWD |
|
· |
|
|
|
|
| Inspect Tires and Check Inflation Pressure |
|
· |
|
|
|
|
| Lubricate MFWD Steering King Pinsb |
|
· |
|
|
|
|
| Lubricate MFWD Front/Rear Axle Trunnionb |
|
· |
|
|
|
|
| Lubricate Adjustable Front (2WD) Axle Steering Spindles and Cylinder Endsb |
|
· |
|
|
|
|
| Lubricate Front Axle Pivot Pointb |
|
· |
|
|
|
|
| Lubricate Hitch Linkage and 3-Point Hitch Bushingc |
|
· |
|
|
|
|
| Inspect Tractor for Loose Hardware |
|
· |
· |
|
|
|
5085M, 5095M, 5095MH and 5105M
INITIAL Change Engine Oil and Filter (Change Break-In Oil to John Deere Plus-50™) |
|
|
· |
|
|
|
| Tighten Air Intake System and Coolant System Hose Clamps |
|
|
· |
|
|
|
5065M and 5075M
INITIAL Engine Oil and Filter Change (When USING or NOT USING John Deere Plus-50™) |
|
|
|
· |
|
|
5065M, 5075M, 5085M, 5095M, 5095MH and 5105M
SCHEDULED Engine Oil and Filter Change (When NOT using John Deere Plus-50™ oil and filter)d |
|
|
|
|
· |
|
| Check MFWD Axle Housing and Wheel Hub Oil Level |
|
|
|
|
· |
|
| Lubricate Draft Sensing Shaft Seal |
|
|
|
|
· |
|
| Drain and Flush Fuel Tank |
|
|
|
|
· |
|
| Check Battery Electrolyte |
|
|
|
|
· |
|
| aIf water is found, run engine for 20 seconds; if more water is collected, drain fuel tank. The fuel filter must be drained when the sediment bowl contains water or sediments. |
| bDaily service if operating in extremely wet and muddy conditions. |
| cService more often if operated in extremely dusty conditions. |
| dSCHEDULED engine oil and filter change interval (300 hours) can be extended to 500 hours if John Deere Plus-50™ oil and John Deere filter are used. |