Use Auxiliary Power Strip-If Equipped

IMPORTANT: Power strip is not a surge suppressor. Electrical equipment with program memory requires protection from electrical surges and spikes.

The power strip provides six outlets of 12 V power with grounds to connect auxiliary equipment. This power is 30 amp switched (key accessory on position) and 30 amp unswitched (key off position).

Adapter plugs (not shown) connect directly into power strip for unswitched power operation. Switched power operation is accomplished by removal of small tab at end of slot on adapter plug. Then rotate adapter plug 180 degrees opposite from unswitched power position.

NOTE: The small white dot on adapter plug face next to cap hinge indicates circuit is unswitched . If dot is opposite cap hinge, circuit is switched .

Adapters are available from your John Deere dealer.

SH20560,0000083 -19-15MAR08-1/1