|
Flow control knob or detent will not turn
|
Dirt build-up.
|
Clean dirt from flow control knob shaft.
|
|
Remote cylinder rate-of-travel too fast or too slow
|
Incorrect flow control adjustment.
|
Adjust flow control.
|
|
Detent does not hold SCV lever
|
Detent selector in wrong position.
|
Turn selector to correct position.
|
|
|
Mid SCV activated.
|
Avoid use of mid SCV.
|
|
|
3-Point Hitch activated.
|
Avoid use of 3-point hitch.
|
|
|
Low Engine rpm.
|
Increase engine rpm.
|
|
|
Pressure restriction with some implements.
|
Reduce oil flow by changing flow control setting.
|
|
|
Flow control or detent setting incorrect.
|
Adjust flow control and/or detent setting.
|
|
SVC lever released too soon
|
Detent selector in wrong position.
|
Turn selector to correct position.
|
|
|
Implement is not connected to SCV-I.
|
Connect implement to SCV-I.
|
|
SCV lever does not release
|
Detent selector not in automatic detent position.
|
Turn selector to correct position.
|
|
|
|
See your John Deere Dealer.
|
|
|
Built-in pressure leakage with some implements.
|
Increase oil flow by changing flow control setting.
|
|
|
Incorrect Flow control.
|
Adjust flow control.
|
|
Rear SCV fails to function
|
Rear SCV does not generate pressure.
|
Check O-ring/back-up ring on power beyond fitting in mid SCV.
|