Position Center Link

The center link attaching bracket has holes which allow four different positions for attaching the center link.

NOTE: Center link attaching bracket can be mounted to provide hole position (D).

If the following conditions occur, move center link to indicated holes to correct.

Condition Use Holes
Rear of implement rises too much when lifted. a A or B
Rear of implement drags the ground. B or C
aThe implement weight which can be lifted is reduced slightly with center link attachment in lower holes.

 

NOTE: Implements with Category I mast height 457 mm (18 in.) will normally use attaching holes (C and D) and implement with Category II mast height 483 mm (19 in.) will use holes (A and B).

PULV000097

Positioning Center Link


A-Upper Hole
B-Middle Hole
C-Lower Hole
D-Lowest Hole (with center link bracket inverted)

SH20560,000012D -19-20MAR08-1/1