Convert Category II Hitch to Category I

Center link end is sized for Category II implement attaching pin.

If Category I implements are to be used, the Category II hitch can be converted as follows:

1. Insert reducer bushing (B) in center link end. Smaller implement mast pin (A) is also needed when bushing is installed.

2. If equipped with fixed link ends, insert a bushing. If equipped with standard telescopic link ends, insert a bushing. If equipped with Deluxe telescopic link ends, exchange balls.

See your John Deere dealer for parts.

NOTE: Category I implements may require center link to be mounted to attaching bracket holes. Refer to "Position Center Link" in this section.


A-Mast Pin
B-Center Link Bushing
C-Draft Link Balls

LV9640

Center Link End

PULV000241

Standard Telescopic Draft Link End

SH20560,0000132 -19-18OCT07-1/1