Level Hitch

1. Lower implement to take weight off hitch and adjust center link to level implement front-to-rear.

a. Rotate center link body with handle (A). DO NOT disconnect center link by rotating body beyond limits. Rotate center link body:

  • CLOCKWISE (C) to lengthen center link.
  • COUNTERCLOCKWISE (B) to shorten center link.

b. Latch locking clip.

IMPORTANT: DO NOT attempt to overextend center link beyond limits of locking clip or lift links past the stops (missed thread). Link body threads could be damaged.

NOTE: Maximum adjustment range of the center link can only be obtained if the ends are positioned equally within the body when attached to an implement.

2. Adjust lift link to level implement side-to-side.

a. Lift locking handle (D) and rotate 90° to engage slot (E) onto roll pin (G). Turn locking handle (D):

  • CLOCKWISE to raise draft link.
  • COUNTERCLOCKWISE to lower draft link.

b. Lift handle (D) and rotate 90° to engage slot (E) onto locking tab (F) of lower body to prevent change of adjustment during operation.

PULV000179
PULV000556
PULV000557


A-Locking Handle
B-Center Link Counterclockwise Rotation
C-Center Link Clockwise Rotation
D-Locking Handle
E-Slot
F-Locking Tab
G-Roll Pin

SH20560,0000134 -19-14JUL08-1/1