Adjust Flow Control-Rear SCV and Mid SCV-If Equipped

CAUTION: Excessive operating speed may cause injury or machine damage.

Decrease flow rate if hydraulic oil overheats, remote cylinder moves too quickly or if hydraulic motor turns too fast.

Flow control adjustment only affects the number I section of Deluxe rear selective control valve (SCV) and the electrohydraulic (grapple) section of the three-function mid SCV. Other valve sections are not affected by this adjustment.

NOTE: Maximum flow possible on electrohydraulic section of three-function mid SCV is 45 L/min (11.9 gal/min).

To INCREASE flow, rotate LEFT (COUNTERCLOCKWISE).

To DECREASE flow, rotate RIGHT (CLOCKWISE).

NOTE: Rear SCV: If detent kicks out before end of cycle, use SCV I and adjust flow control.

A-Flow Control Knob

SH20560,000013F -19-08MAY08-1/1