Service Daily Before Start-Up

IMPORTANT: Do not operate when oil level is below lower mark on dipstick.

1. Check engine oil level. Wipe dipstick (A) off and reinsert it fully. Remove and check oil level.

2. If operating in extremely wet or muddy conditions, lubricate the following at the 10-hour service interval with multipurpose grease:

  • Front axle pivot pin
  • Steering spindles and cylinder ends (adjustable front axle)
  • King pins (MFWD)
  • Rear axle bearings

3. Lubricate with multipurpose grease:

  • Hood latch
  • Operator's seat slide rails


A-Engine Oil Dipstick
B-Engine Oil Filler Cap

PULV000071

5065M and 5075M

PULV000069

5065M and 5075M

PULV000060

5085M, 5095M, 5095MH and 5105M

SH20560,000015E -19-24APR08-1/1