Attach PTO-Driven Implement

1. CAUTION: Stop engine before attaching implement or working in area of implement hitch.

   
   PY1094-UN-10APR05

   Attach implement to tractor before connecting PTO drive line. Raise hitch to upward position if it is not to be used.

---




2. Gear shift lever in neutral (N), turn key to OFF position, pull fuel shut-off knob to stop engine and set brakes.

3. Attach implement to 3-Point Hitch, be sure drawbar will not interfere. Remove it if necessary.

4. Rotate PTO shield upward for clearance. With engine off, turn shaft slightly by hand if necessary to line up splines. Connect drive line to PTO shaft. Pull out on shaft to be sure drive line is locked to PTO shaft. Place PTO shield in downward position.

5. Be sure all shields are in place and in good condition. Never operate PTO unless master shield is properly installed. WITH ENGINE STOPPED, check integral shields on drive line by making sure they rotate freely on shaft. Lubricate or repair as necessary.

6. Check carefully for any interference, make sure hitch is raised to the upper position if it is not used.