Change Transmission-Hydraulic Oil and Filter—With Sight Glass

NOTE: Sight glass is provided to the tractors with reverse PTO option.

1. 
   PY6278-UN-09OCT06

   Transmission Drain Plug

   
   PY42584-UN-31JUL17

   Drop Housing Drain Plug

   
   PY42585-UN-31JUL17

   A - Transmission Case Drain Plug

   B - MFWD Drop Housing Drain Plug

   C - Oil Filter

   Lower rockshaft to remove trapped oil.

---




2. NOTE: The approximate transmission case oil capacity is 38 L (10 gal) for 2WD tractors and 39 L (10.30 gal) for MFWD tractors.

   For, Wet clutch the transmission case oil capacity is 43 L (11.36 gal) for 2WD tractors and 48 L (12.68 gal) for MFWD tractors.

   Remove drain plug (A) from transmission case and drain out oil. Dispose of waste oil properly.

3. If equipped with the MFWD axle, also remove drain plug (B) in the drop housing.

4. Replace filter (B) while changing oil. Apply a film of oil to the new filter gasket and install new filter. Hand tighten only.

5. Fill system with transmission-hydraulic oil. (See Fuels, Lubricants, and Coolant section.)

   Item	Measurement	Specification
   Transmission Oil (2WD)	Capacity	38 L (10 gal)
   Transmission Oil (MFWD)	Capacity	39 L (10.30 gal)
   For Wet Clutch Transmission Oil (2WD)	Capacity	43 L (11.36 gal)
   For Wet Clutch Transmission Oil (MFWD)	Capacity	48 L (12.68 gal)

6. 
   APY12803-UN-02MAY24

   For Dual Clutch Dual PTO variants

   
   APY12858-UN-05OCT18

   B - Full Level Mark

   C - Add Level Mark

   Check oil level at sight glass after filling. Make sure that oil level is to the full level mark (B). Check again after operating for five minutes. Add oil if necessary.

---