Service Interval Chart

Item

Every 600 Hours

Every 1200 Hours

Every 1800 Hours or Annual

Every 2000 Hours or Two Years

First Three Years or 3000 Hours

First Five Years or 5000 Hours

Replace Transmission-Hydraulic Oil Filter 1

         

Change MFWD Hub and Axle Housing Oil

         

Clean Engine Crankcase Vent Tube

         

Check Cooling System for Leaks

         

Lubricate Rear Axle Bearings 2

         

Check Engine Idle Speeds

         

Check Front Axle Pivot Pin End Play 3

         

Inspect, and Tighten Hose Clamps on the Air Intake System and Coolant System

         

Service/Clean Primary and Secondary Engine Air Filter Elements

 

       

Clean Transmission-Hydraulic Oil Pick-up Screen

 

       

Check Belt Tensioner

 

       

Change Transmission-Hydraulic Oil and Filter

 

       

Replace and/or Clean Cab Air Filters 4

   

     

Inspect Seat Belt

   

     

Check Coolant Properties 3

   

     

Adjust Engine Valve Clearances 3

     

   

Test Injection Nozzles 3

     

   

Drain, Flush and Replace Coolant (When coolant is NOT checked annually or not serviced with the pre-diluted John Deere COOL-GARD II™)3

       

 

Test or Replace Thermostat 3

       

 

Drain, Flush and Replace Coolant

         


COOL-GARD is a trademark of Deere & Company
1 Using a shop-vac, apply suction to the fill port during filter change to prevent draining of the hydraulic oil.
2 Daily Service is only necessary when operating in extremely wet and muddy conditions. Greasing too frequently can cause seal fatigue.
3 See your John Deere dealer for service.
4 Service more often if operated in extremely dusty conditions.

JZ81662,00007AD-19-20120522