Set MFWD Steering Stops Turning Radius

PY6505-UN-06NOV06

A - Steering Stop Locking Nut

B - Steering Stop Bolt

C - Steering Stop

1. Raise and support the front of the tractor so the MFWD axle can be oscillated to its stops.

2. Slowly turn the steering wheel to the left until the steering cylinder travel has reached its limit, the steering stops, or the tires are within 25 mm (1 in.) of the grille screen or the side panels.

3. Raise the left side of the axle against its stop and measure the clearance between the tire and the nearest tractor component. The distance should not be less than 25 mm (1 in.).

4. Loosen the locking nut (A) on the steering stop and adjust the steering stop bolt (B) so it touches the steering stop (C). It may be necessary to shorten the stop bolt (B) in order to obtain the maximum turning angle.

5. Tighten steering stop bolt retaining lock nut (A) as per specification.

6. Turn wheel fully to the left. Impact knuckle housing to steering stop five times.

7. Tighten steering stop bolt retaining nuts again to specification.

   Item	Measurement	Specification
   Steering Stop Bolt Retaining Lock Nut	Torque	125 N˙m (92 lb-ft)

8. Repeat above steps for the right side.

NOTE: Wide tread settings and large tire sizes will increase turn radius slightly.