Change Transmission-Hydraulic Oil and Filter

PY4417-UN-31DEC04

PY4434-UN-26JUL07

A - Transmission Case

B - Filter

C - Drain Plug

D - Dipstick

1. Lower rockshaft to remove trapped oil.

2. NOTE: The approximate transmission case oil capacity is 38 L (10 gal)

   Remove drain plug from transmission case (A) and drain out oil.

3. Replace filter (C) while changing oil. Apply a film of oil to new filter gasket and install new filter. Hand tighten only.

4. Fill system with transmission-hydraulic oil. (See Fuels, Lubricants, and Coolant section.)

   Item	Measurement	Specification
   Transmission Oil	Capacity	38 L (10 gal)

5. If dipstick is equipped: Check oil level at dipstick (D) after filling, and check again after operating for five minutes.

6. 
   PY11298-UN-07FEB11

   If Equipped

   B - Full Level Mark

   C - Low Level Mark

   If sight glass is equipped: Check oil level at sight glass (B) is to the full mark and check again after operating for five minutes.

---