Leveling the Hitch

PY4968-UN-02MAY07

MITA Rockshaft (If Equipped)

PY15117-UN-03APR12

A - Locking Clip

B - Center Link Body

C - Locking Handle

D - Slot

1. Lower implement to take weight off hitch.

2. IMPORTANT: DO NOT attempt to overextend center link beyond limits of locking clip or lift links past the stops. Link body threads could be damaged.

   NOTE: Maximum adjustment range of the center link can only be obtained if the ends are positioned equally within the body when attached to an implement.

   Adjust center link to level implement front-to-rear. Unlatch locking clip (A). Rotate center link body (B) clockwise to lengthen center link or counterclockwise to shorten it. Be sure to latch the locking clip.

3. Adjust right-hand link to level implement side-to-side. Lift locking handle (C) and turn 1/4 turn to engage slot (D) onto roll-pin in the center portion of the lift link.

   Turn crank handle (C) clockwise to raise draft link.

   Turn crank handle (C) counterclockwise to lower draft link.

   After adjustment, lift handle (C) and turn to engage slot (D) onto the lower body to prevent change of adjustment during operation.

4. The left-hand lift link is also adjustable in length to accommodate different tyre sizes.

   To change the left-hand lift link length, remove the upper lift link pin and rotate the upper end assembly clockwise to shorten or counterclockwise to lengthen, and then reinstall the upper pin and locking pin.

   Adjust left and right lift links to accommodate various tyre sizes. Set the lift links to have fully-lowered draft link balls approximately seven inches off the ground for greatest range of usable hitch motion.