Check Toe-In

APY36650
APY36650-UN-15OCT20

A - Front Axle Toe-In Distance

  1. Park machine on level surface.

  2. Turn steering wheel so front wheels are in the straight-ahead position. Stop engine.

  3. Measure distance (A) between tyres at hub level in front of axle. Record measurement and mark the tyres.

  4. Move tractor back about 1 m (3 ft), so mark is at hub level behind the axle. Again, measure distance between tyres at same point on tyre. Record measurement.

  5. Determine the difference between front and rear measurements. If the front measurement is smaller, toe is “in”. If the rear is smaller, toe is “out”.

  6. Distance (A) at front of tyres should be 3—6 mm (1/8—1/4 in.) less than distance measured at rear of tyres. Adjust toe-in if necessary. (See procedure in this section.)

WKJQUWJ,0000882-19-20201015