Operate Foldable ROPS

APY41718-UN-25JUN21

ROPS — Operating Position

APY41941-UN-25JUN21

PY1421-UN-20MAY03

ROPS—Folded

A - ROPS Crossbar

B - Quick-lock Pins

C - Headed Pins

CAUTION: Make certain all parts are installed correctly if roll-over protective structure (ROPS) is loosened or removed for any reason. Tighten mounting bolts to the proper torque.

The protection offered by ROPS is impaired if ROPS is subjected to structural damage, as in an overturn incident, or is in anyway altered by welding, bending, drilling, or cutting. A damaged ROPS should be replaced, not reused. Any alteration to the ROPS must be approved by the manufacturer.

Always keep upper part of ROPS pinned in vertical position (as pictured) when operating tractor. If tractor is operated with ROPS folded (for example, to enter a low building) drive with extreme caution and DO NOT use seat belt.

Fold the ROPS up again as soon as the tractor is operated under normal conditions.

To Lower ROPS Crossbar (A):

1. Remove quick-lock pins (B) and headed pins (C).

2. Lower crossbar (A) of ROPS onto stops.

3. Reinstall pins (C and B) into holes in ROPS to lock crossbar down.

To Put ROPS in Operating Position:

1. Remove quick-lock pins (B) and headed pins (C).

2. Lift crossbar (A) of ROPS to position shown.

3. Install pins (C) and quick-lock pins (B).