Service Interval Chart—Daily or 10 Hours / Every 50 Hours / First 100 Hours / Every 250 Hours

Item

Daily or 10 Hours

Every 50 Hours

First 100 Hours

Every 250 Hours

Check engine oil level

     

Check coolant level

     

Drain water from water separator bowl

     

Drain water and sediment from fuel tank and fuel filter1

     

Lubricate front axle pivot pins 2

     

Lubricate rear axle bearings 2

     

Lubricate tie rod ends(2WD)2

     

Lubricate Steering Linkage(2WD)2

     

Clean and check battery

 

   

Inspect all tires

 

   

Lubricate front axle pivot pins

 

   

Check transmission-hydraulic system oil level

 

   

Check MFWD axle hub oil level

 

   

Inspect tractor for loose nuts and bolts

 

   

Lubricate Steering Linkage(2WD)2

 

   

Replace transmission-hydraulic oil filter

   

 

Change engine break-in oil and filter

   

 

Inspect hose clamps on the air intake system & coolant system

   

 

Service air cleaner3

     

Check oil level in MFWD axle and wheel hubs

     

Inspect alternator/fan belt

     

Lubricate 3-point hitch

     

Change engine oil and filter

     

Replace transmission-hydraulic oil filter

     

Adjust clutch free play 4

     

Check neutral start system

     

1 The fuel filter must be drained when water or debris is evident in the sediment bowl. If this reoccurs more than three days in a row, then drain the sediment from the fuel tank. Run engine for a minimum of 20 seconds, re-check and if more water collects, drain the fuel tank.
2 Only necessary in extremely wet or muddy conditions
3 Service more often if operated in extremely dusty conditions.
4 For Mechanical dry clutch

SD74272,00000FF-19-20140821