Prepare Implement

IMPORTANT: When attaching Category I implements to the tractor, sway chains may need lengthening to prevent binding and limiting full raise of the hitch. (See Adjust Hitch Side Sway in this section.)

PY23270-UN-06FEB15

Category I 3-Point Hitch is narrower and is used on smaller implements than category II implements. Refer to the chart below to identify implement category.

Category I implements should have the top hole of the implement mast located 457 mm (18 in.) above the lower pin.

Category I	Mast Height	Width Between Lower Pins	Pin Size
			Lower	Upper
I	457 mm (18 in.)	682.6 mm (26-7/8 in.)	22 mm (7/8 in.)	19 mm (3/4 in.)