Service Daily Before Start-Up
1.
Check engine oil level. (See CHECK ENGINE OIL LEVEL in Lubrication section.)
2.
Check hydraulic oil level through sight glass. (See CHECK TRANSMISSION/HYDRAULIC SYSTEM OIL LEVEL in Lubrication section.)
3.
Drain water and sediment from fuel filters. (See procedure in Maintenance-Fuel System section.)
4.
Check level in coolant overflow reservoir. (See CHECK COOLANT LEVEL in Maintenance-Cooling System section.)
IMPORTANT:
If operating in extremely wet or muddy conditions, lubricate several additional components daily.
5.
If operating in extremely wet or muddy conditions, lubricate the following at 10-hour service intervals (See procedures in Lubrication section):
-
Front axle pivot pin
-
Steering linkage
-
MFWD shaft
-
Front wheel bearings (2WD)
-
Rear axle bearings
-
Hood latch
-
Operator's seat slide rails (OOS)
|