Stopping the Engine

IMPORTANT: Certain engine parts are cooled by engine oil. Stopping a hot engine could cause damage by overheating or lack of lubrication.

1. Pull hand throttle (E) down to slow idle position.

2. Put gear shift lever (A) or PowrReverser™ lever (B) (if equipped) in NEUTRAL.

3. Lock brake pedals together using bar (C).

4. Push brake pedals down and pull up on lever (D) to set parking brake.

5. Lower all equipment to the ground, put all SCV levers in NEUTRAL and disengage PTO.

6. Allow engine to idle for one to two minutes.

CAUTION: Remove key from ignition switch to prevent operation by untrained personnel.

7. Turn key (F) to STOP and remove from switch.

A-Gear Shift Lever
B-PowrReverser™ Lever (If Equipped)
C-Brake Pedals Locking Bar
D-Parking Brake Lever (If Equipped)
E-Hand Throttle Lever
F-Key

PX03972,0000546 -19-17DEC08-1/1