|
Perform the following steps to remove tractor from storage:
1.
Remove covering placed in or on tractor while storing it.
2.
Inspect tires and check tire inflation pressure. (See Wheels, Tires and Threads Section, in Maintenance Guide.)
3.
Unseal all opening sealed prior to storage.
4.
Install battery and install cables.
5.
Install auxiliary belt drive on fan pulley.
6.
Check levels of engine oil, transmission-hydraulic oil, and engine coolant. Add if necessary.
7.
Drain a small amount of fuel from fuel tank to purge any moisture condensation that has collected.
8.
Fill fuel tank.
|
9.
Perform all appropriate 10-hour, weekly or 50-hour, 100-hour, 300-hour, 500-hour, and 600-hour services as instructed in Maintenance and Service Intervals section of Maintenance Guide.
10.
Check all instruments and indicators by turning ignition switch to ON position.
11.
Connect fuel shut-off solenoid wiring lead/connector.
12.
Crank engine for a few revolution.
IMPORTANT:
DO NOT operate starter more than 20 seconds at a time, and wait at least two minutes for starter to cool before trying again.
13.
Start the engine.
14.
Operate engine at low idle for some time.
15.
Check all other system functions.
|