Operate Mechanical Position Control-If Equipped

CAUTION: To prevent unexpected movement, put draft control lever (B) in full forward position before attaching implement.

Rear hitch position control lever (A) controls raise or lower movement of 3-point hitch mounted implement and ground depth penetration.

A-Position control lever
B-Draft control lever
C-Position control lever stop wheel

AJ20558,00002FA -19-02SEP09-1/3

IMPORTANT: Draft control setting automatically influences actual hitch position. For independent position control, move draft control lever (B) in fully forward position.

NOTE: A few minutes of implement operation may be required to determine best depth. Set desired depth with stop wheel (C). Hitch returns implement to previous above or below ground depth.

Depth Control (level, in-ground, on-ground, and non-ground engaged situations): Position lever (A) at desired depth.

AJ20558,00002FA -19-02SEP09-2/3

Float Control (uneven, ride on-ground contour situations): Position lever (A) and draft control lever (B) fully forward.

NOTE: Ensure implement skids or height gauge wheels are set correctly to carry full implement weight. Ensure hitch draft link arms are adjusted for any required lateral float.

Height at Turn (end of field turn around situations): Position lever (A) rearward until implement is out of ground.

Implement Transport (load and non-load sense usage): Position lever (A) fully rearward.

AJ20558,00002FA -19-02SEP09-3/3