Starting the Engine

TS177-UN-11JAN89

LV12797-UN-04OCT06

LV12799-UN-04OCT06

A - Hand Throttle

B - Key Switch

CAUTION: NEVER start engine while standing on ground. Do not start engine by shorting across starter terminals. Machine will start in gear and move if normal circuitry is bypassed.

IMPORTANT: DO NOT run a cold engine at full throttle. Idle engine at 1200 rpm until it warms to operating temperature.

1. Start from operator’s seat with transmission in neutral or park. For PowrReverser™ Transmission, put EH directional reverser lever in NEUTRAL.

2. Push hand throttle (A) forward from idle position (approximately 1/3 of full throttle). Engine may not start with throttle pulled completely down.

3. IMPORTANT: DO NOT operate starter for more than 20 seconds at a time. If engine does not start, wait at least 2 minutes for the starter motor to cool before trying again.

   Depress clutch pedal and turn key (B) to START position. Release key when engine starts. If key is released before engine starts, wait until starter and engine stop turning before trying again.

4. Warm up tractor carefully. Charging and oil pressure warning indicators should go off and stay off. Coolant temperature gauge should begin to move into normal range.

5. Avoid unnecessary engine idling. Check fluid levels frequently for engine oil, coolant, transmission-hydraulic, and mechanical front wheel drive. Watch for fluid leaks.