OMSU21740

Symptom	Problem	Solution
Insufficient transport clearance height	Very long center link	Adjust center link.
	Very long lift links	Adjust lifts.
	Uneven implement	Level the implement.
	Upper center link in upper holes	Move center link to lower holes.
	Short stabilizer chains	Lengthen chains.

Hitch drops slowly

Hitch rate of drop not correctly adjusted

Adjust rate-of-drop.

Hitch does not rise or rises slowly	Excessive load on hitch	Reduce load.
	Low oil level	Fill up system with correct oil.
	Hydraulic oil too cold	Allow oil to warm up adequately
	Plugged transmission/hydraulic system oil filter	Change filter.
	Transmission/hydraulic mesh filter obstructed	Clean or change mesh

Implement does not work at depth required	Lift links too short	Adjust lifts
	Lack of penetration	Refer to Operator's Manual of implement.
	Incorrect limiter adjustment	Reposition limiter.
	Incorrect draft lever adjustment	Refer to section“Hydraulic Hitch and 3-Point Hitch ”

Insufficient or no hitch response to load	Upper center link in upper holes	Move center link connection to lower holes of support
	Position control lever “disconnected”	Move lever backwards.
	Lift links too short	Adjust lifts
	Lack of penetration	Refer to Operator's Manual of implement.
	Rate of drop very slow	Adjust rate-of-drop valve.

Hitch varies greatly

Front of center link connected to lower support holes

Move center link connection to upper support holes

Hitch drops too quickly

Rate of drop too fast

Adjust rate-of-drop.

GB52027,0000060-19-20060630