Service—As Required

• Service Engine Air Cleaner—Service after Air Restriction Indicator is ON ^{1 2}
• Adjust PTO Speed Shift Lever—Open Operator’s Station ³
• Lubricate Axle Pivot Point—2WD⁴
• Lubricate Steering Spindles and Steering Cylinder Ends—Adjustable Front Axle ⁴
• Lubricate Rear Axle Bearings ⁴
• Lubricate Draft Sensing Shaft Seal ⁴
• Adjust PTO Speed Shift Lever—Cab ³
• Adjust Hand Throttle Friction Linkage ³
• Adjust Hand and Foot Throttle Cable ³
• Adjust Clutch Pedal Cable—If Equipped withSyncShuttle Plus™ Transmission ³
• Adjust Park Position Bracket ³
• Adjust Rear Fender—Open Operator’s Station and Low Profile
• Clean Cab Air Filters—If Equipped ²
• Service Air Conditioner—If Equipped ³
• Test Injection Nozzles ³
• Drain and Flush Fuel Tank ³
• Clean and Check Battery Condition
• Clean Grille Screens, Radiator, Oil Cooler, Radiator Screen (If Equipped) and A/C Condenser (Cab)
• Keep ROPS Installed Properly—Open Operator's Station
• Keep ROPS Installed Properly—Low Profile
• Keep Cab Protection System Installed Properly
• Bleed Fuel System
• Replace Battery
• Locate Fusible Links
• Locate Fuses—Open Operator's Station
• Locate Fuses—Low Profile
• Locate Fuses—Cab
• Fuse and Relay Size and Function
• Replace Headlight Bulb
• Replace Warning Light Bulb—Cab
• Replace Turn/Warning Light Bulb—Low Profile
• Replace Tail Light Bulb—Cab, Deluxe OOS and Low Profile
• Replace Tail Light and/or Warning Light Bulb—Open Operator's Station
• Replace Work Light Bulb—Open Operator's Station and Low Profile
• Replace Work Light Bulb—Cab
• Replace Fender Light Bulb—Open Operator's Station
• Replace Loader Light Bulb—If Equipped
• Replace Dome Light Bulb—Cab
• Replace Controls Illumination Light Bulb—Cab
• Replace Rotary Beacon Light Bulb—If Equipped
• Service Exhaust Filter ³
• Replace OCV Filter ³

NOTE: For maintenance procedure, refer to Maintenance Guide.