OMSU30056

Service Interval Chart

Service Chart — Daily (10 Hours) to 600 Hours

Item	Daily or 10 Hours	Weekly or 50 Hours	First 100 Hours	Every 300 Hours	Every 500 Hours	Every 600 Hours
Check Engine Oil Level	•
Drain Water and Sediment from Fuel Filter ¹	•
Air Filter Unloader Valve	•
Check Coolant Level		•
Check Transmission-Hydraulic System Oil Level		•
Look for Oil Leak at MFWD		•
Inspect Tires and Check Inflation Pressure		•
Lubricate MFWD Front/Rear Axle Trunnion²		•
Lubricate Adjustable Front (2WD) Axle Steering Spindles and Cylinder Ends²		•
Lubricate Front Axle Pivot Point²		•
Lubricate Hitch Linkage and 3-Point Hitch Bushing³		•
Inspect Tractor for Loose Hardware		•	•
INITIAL Change Engine Oil ⁴ and Filter (Change Break-In Plus™ Oil to John Deere Plus-50™ II)			•
Change Transmission-Hydraulic Filter ⁵			•
Tighten Air Intake System and Coolant System Hose Clamps			•
Check MFWD Axle Housing and Wheel Hub Oil Level				•
Lubricate Draft Sensing Shaft Seal				•
Drain and Flush Fuel Tank				•
Check Battery Electrolyte				•
Change Engine Oil and Filter SCHEDULED: Engine Oil and Filter Change (When USING John Deere Plus-50™ II oil and filter)					•
Replace Fuel Filter					•
Clean Cab Air Filters ³						•
Check Neutral Start System						•
Change MFWD Hub and Axle Housing Oil						•
Clean Engine Crankcase Vent Tube						•
Repack Adjustable Front (2WD) Axle Wheel Bearings						•
Lubricate Rear Axle Bearings						•
Check Front Axle Pivot Pin End Play ⁶						•
Tighten Air Intake System and Coolant System Hose Clamps						•
Change Transmission-Hydraulic Filter ⁵						•

NOTE: For maintenance procedure, refer to Maintenance Guide.

Break-In Plus is a trademark of Deere & Company

Plus-50 is a trademark of Deere & Company
¹ If water is found, run engine for 20 seconds; if more water is collected, drain fuel tank. The fuel filter must be drained when the sediment bowl contains water or sediments.
² Daily service if operating in extremely wet and muddy conditions.
³ Service more often if operated in extremely dusty conditions.
⁴ If engine has to much operating time at idle, constant speeds, and/or light load usage, or make-up oil is required during the first 100-hour period, a longer break-in period may be needed without changing Break-In Plus oil until 500 hours.
⁵ Using a shop vac, apply suction to the fill port during filter change to prevent draining of the hydraulic oil.
⁶ See your John Deere dealer for service.

OUO1023,0002F38-19-20111003