Operating Foldable ROPS

PULV008119-UN-23FEB10
ROPS—Vertical Operating Position

LV9729-UN-03SEP04

PULV008120-UN-23FEB10
ROPS—Folded
A - ROPS Crossbar
B - Headed Pin
C - Lock Pin
CAUTION: Make certain all parts are installed correctly if roll-over
protective structure (ROPS) is loosened or removed for any reason.
Tighten mounting bolts to proper torque. The protection
offered by ROPS will be impaired if ROPS is subjected to structural
damage, as in an overturn incident, or is in any way altered by welding,
bending, drilling or cutting. A damaged ROPS should be replaced, not
reused. Any alteration to the ROPS must be approved by the manufacturer.
Always keep upper part of ROPS pinned in vertical position (as
pictured) when operating tractor. If tractor is operated with ROPS
folded (e.g., to enter a low building) drive with extreme caution
and DO NOT use seat belt.
Lift the ROPS up again and pin in vertical position as soon
as the tractor is operated under normal conditions.
Lower ROPS Crossbar (A):
-
Remove lock pins (C) and headed pins (B).
-
Lower crossbar (A) of ROPS onto stops.
-
Reinstall pins (B and C) into holes in ROPS brackets to lock
crossbar down.
Put ROPS in Operating Position:
-
Remove lock pins (C) and headed pins (B).
-
Lift crossbar (A) of ROPS to vertical position.
-
Reinstall pins (B and C) into holes in ROPS to lock in position.
|
|
SP55916,00004E2-19-20100223
|
|