Information Display (Roll Mode Switch)
PY16304-UN-08AUG12
PY16688-UN-15OCT12
A - Roll Mode Switch
B - LCD Display
Roll mode switch (A) controls two different information display
modes, "Normal" and "Diagnostic".
Information Display - Normal Mode
Roll mode switch (A) and information display (B) default to
the normal mode. In normal mode: Information display (B) provides
a numeric representation of engine hours, vehicle speed, or PTO speed.
-
Press and release the roll mode switch (A) to cycle through
the display (B) values (engine hours, vehicle speed, and PTO speed).
Roll Mode Sequence Order
|
Engine Hours
|
Vehicle Speed
|
PTO Speed1
|
Regeneration Progress Stage 12
|
Regeneration Progress Stage 22
|
Regeneration Progress Stage 32
|
-
Engine hours are displayed when the key switch is first turned
on.
-
Engine hours are displayed for at least 7 seconds prior to automatically
switching to any other value.
-
The display (B) automatically transitions to the vehicle speed
when the tractor begins moving.
-
The display (B) automatically transitions to PTO speed when
the PTO is engaged.
-
The display (B) disables automatic scrolling once the roll mode
switch (A) is pressed or used to scroll through display modes.
-
The PTO speed is only displayed, when the enable PTO speed display
is configured in ICC diagnostic address 026 (1 = enabled) [If vehicle
is equipped with electro-hydraulic PTO.]
-
The display (B) only re-enables automatic scrolling when the
key switch is cycled on and off.
-
During exhaust filter cleaning process, the display (B) transitions
through the various exhaust filter cleaning states.
Information Display - Diagnostic Mode
The diagnostic mode has two levels of access; “Customer”
and “Technician”.
-
Customer access = Press and hold roll mode switch for 5 seconds
to begin diagnostic session. This allows access to see diagnostic
trouble codes and a limited amount of diagnostic addresses.
-
Technician access = Only for John Deere dealer
use. Accesses everything in customer mode plus vehicle set
up, configuration, and calibration.
Customer access; recall, record, and clear
diagnostic trouble codes:
-
Press and hold the roll mode switch for 5 seconds to begin diagnostic
session.
-
Upon entering diagnostic, any active or previously active codes
will automatically appear in a scrolling fashion with each one showing
the control unit (3 letter abbreviation) and the code number (XXXXXX.XX).
-
To view and /or clear diagnostic trouble codes for any given
control unit, you must do the following:
-
Use the right turn signal switch to scroll to the desired control
unit.
-
Press and release the roll mode switch to enter the diagnostic
addresses for that desired control unit.
-
Use the right turn signal switch to scroll to diagnostic address
001 for that desired control unit.
-
If codes are present the word “codes” will appear.
If not, the word “none” will appear.
-
Press and release the roll mode switch to view all codes details
for this control unit.
-
Any codes present in that control unit will appear there in
scrolling fashion for multiple codes.
-
To access the option for clearing codes for this selected control
unit, present and release the right turn signal switch.
-
The question “CLR?” will appear.
-
To clear the codes, press and release the roll mode switch.
-
To go back to the entire control unit list, press and release
the left turn signal switch.
-
Proceed to the next desired control unit by repeating steps
1-10.
1 If Equipped.
2 Item(s) shall only be available when a valid
value is present.
|
SP21231,000006F-19-20130115
|
|