Checking Toe-In - 4X2 Axle

LV9463-UN-24JUL04

Check toe-in as follows:

1. Park tractor on level surface.
2. Turn steering so that front wheels are in a straight line. Shut off engine.
3. Measure distance (A) (front part of axle) at hub level. Write down measurements and mark tires.
4. Move tractor over approximately 1m (3 ft) so that the mark is at hub level, but behind the axle. Measure the distance between the tires at the same point. Write down measurements and mark tires.
5. Determine the difference between the measurements. If front measurement is smaller, adjust inner toe-in. If rear measurement is smaller, adjust outer toe-in.
6. Measurement (A) at front of tires should be between 3 — 6 mm (1/8 — 1/4 in.) smaller than measurement at rear side of tires.
7. Adjust toe-in if necessary.