Adjusting Sway Stabilizers

CQ294925
CQ294925-UN-28NOV13

With implement coupled to tractor, on a level surface:

  1. Raise implement to transport position (half way up).

  2. Remove locking pins (A) from both stabilizers.

  3. Push implement to both sides so that it is aligned (centered). If necessary, turn spindle (B) to make installation holes coincide with pin.

    Maximum recommended opening of stabilizers is 450 (17.7 in.) mm from center to center.

    Do not shorten stabilizers so much that they impede the hitch arms rising up fully. If arm movement of hitch is blocked, relief valve will open and this will overheat hydraulic oil and damage pump.

  4. Use a spring or a rubber band to keep arms not in use away from rear tires.

  5. To allow implement oscillates laterally while working, install locking pins (A) to elongated holes (C).

    Consult Operator's Manual of implement to check if lateral oscillation is permissible.

OU90500,0000190-19-20131128