Service Interval Chart

Service Chart — Daily (10 Hours) to 600 Hours

Item

Daily or 10 Hours

Weekly or 50 Hours

First 100 Hours

Every 300 Hours

Every 500 Hours

Every 600 Hours

Check Engine Oil Level

         

Drain Water and Sediment from Fuel Filter 1

         

Check Compressed Air System

         

Check Lights

         

Clean Dust Unloading Valve

         

Check Coolant Level

 

       

Check Transmission-Hydraulic System Oil Level

 

       

Look for Oil Leak at MFWD

 

       

Inspect Tires and Check Inflation Pressure

 

       

Lubricate MFWD Front/Rear Axle Trunnion 2

 

       

Lubricate Adjustable Front (2WD) Axle Steering Spindles and Cylinder Ends2

 

       

Lubricate Front Axle Pivot Point2

 

       

Lubricate Hitch Linkage and 3-Point Hitch Bushing 3

 

       

Inspect Tractor for Loose Hardware

 

       

Change Engine Oil and Filter (Change Break-In Plus™ Oil to John Deere Plus-50™ II) 4

   

     

Change Transmission-Hydraulic Filter

   

     

Tighten Air Intake System and Coolant System Hose Clamps

   

     

Inspect Tractor for Loose Hardware

   

     

Check MFWD Axle Housing and Wheel Hub Oil Level

     

   

Lubricate Trailer Hitch and Check That it Functions Properly

     

   

Check for Wear at Components of Drawbar and Trailer Hitch

     

   

Lubricate Draft Sensing Shaft Seal

     

   

Drain and Flush Fuel Tank

     

   

Clean and Check Battery Condition

     

   

Inspect and Adjust Alternator Belt (5075M)

     

   

Inspect and Adjust A/C Compressor Belt (5075M Cab)

     

   

Inspect and Adjust Air Compressor Belt (5075M)

     

   

Change Engine Oil and Filter (When using John Deere Plus-50™ II oil and filter)

       

 

Replace Fuel Filter

       

 

Clean Cab Air Filters 3

         

Check Neutral Start System

         

Change MFWD Hub and Axle Housing Oil

         

Clean Engine Crankcase Vent Tube (Except 5075M)

         

Repack Adjustable Front (2WD) Axle Wheel Bearings

         

Lubricate Rear Axle Bearings

         

Check Front Axle Pivot Pin End Play 5

         

Tighten Air Intake System and Coolant System Hose Clamps

         

Change Transmission-Hydraulic Filter

         


Break-In Plus is a trademark of Deere & Company

Plus-50 is a trademark of Deere & Company
1 If water is found, run engine for 20 seconds; if more water is collected, drain fuel tank. The fuel filter must be drained when the sediment bowl contains water or sediments.
2 Daily service if operating in extremely wet and muddy conditions.
3 Service more often if operated in extremely dusty conditions.
4 If engine has to much operating time at idle, constant speeds, and/or light load usage, or make-up oil is required during the first 100-hour period, a longer break-in period may be needed without changing Break-In Plus oil until 500 hours.
5 See your John Deere dealer for service.

JZ81662,00010ED-19-20130731