Service Daily Before Start-Up

IMPORTANT: Do not operate when oil level is below lower mark on dipstick.

For any off level operation, engine oil must be maintained at the FULL mark to avoid engine damage.

1. Check engine oil level. See “Engine Maintenance” section for procedure.

2. Raise hood. Clean dust unloading valve. See “Air, Fuel, Coolant, and Exhaust Maintenance” section for procedure.

3. Check transmission-hydraulic oil. See “Hydraulics Maintenance” for procedure.

4. Inspect machine for damage. Repair as needed before operation.

   • Debris around cooling package
   • Exhaust and engine areas
   • Mud and field debris buildup
   • Low tire pressure
   • Loose hardware
   
   

5. If operating in wet or muddy conditions, lubricate the following at the 10 hour service interval with multipurpose grease:

   • Front axle pivot pin
   • Rear axle bearings
   • Front and rear hitch