Insufficient transport clearance.
Adjust center link.
Lift links too short.
Adjust lift links.
Implement not level.
Level implement.
Hitch feedback linkage not properly adjusted.
See your John Deere dealer.
Implement not properly adjusted.
See implement operator's manual.
Front of center link in upper holes.
Move center link to lower holes.
Sway bars too short.
Adjust sway bars.
Raise height limit not correctly set.
Adjust raise height limit.
Hitch fails to follow the lever.
Poor position control.
Turn load/depth mix control to “position” control detent.
System is reset (fender switches override operator control).
Enable system with operator control.
Malfunction in the lever position sensor or hitch position sensor.
Hitch drops slowly.
Adjust rate-of-drop.
Hitch fails to lift or lifts slowly.
Reduce load.
Center link in wrong position.
Low oil level.
Fill system with proper oil.
Hydraulic oil too cold.
Allow oil to warm.
Transmission-hydraulic oil filter clogged.
Replace filter.
Implement does not operate at desired depth.
Lack of penetration.
Draft sensor failed.
Improper setting of the hitch control stop.
Adjust position.
Improper setting of load/depth control.
Adjust load/depth for the implement type.
Insufficient or no hitch response to draft load.
Turn load/depth mix control to higher setting.
System is reset.
Enable system.
Rate-of-drop too slow.
Hitch too responsive.
Turn load/depth mix control to lower setting.
Hitch drops too fast.
Hitch settles too fast after machine is parked and engine shutoff.
Hitch does not move (controls not working, including external raise/lower switch).
Replace fuses.
External raise/lower switch does not move hitch.
Hitch codes are present.
BH38674,00003D1-19-20161006