Start Engine

TS177-UN-11JAN89

RXA0152805-UN-13JUL16

Left-Hand Reverser

CAUTION: Do not start engine by shorting across starter terminals. Machine starts in gear if the normal circuitry is bypassed. Start engine ONLY from the operator's seat.

Avoid possibility of personal injury or death. Engine starting with shift lever in gear indicates malfunction of the starting circuit. Repair immediately. See your John Deere dealer.

Avoid possibility of serious injury or death. Be sure that machine and attached equipment are clear of people and other objects.

IMPORTANT: DO NOT use starting fluid. Damage to engine can occur.

1. Check fuel, engine oil, and coolant levels before starting the engine. Fill as required.

2. Place transmission shift lever in park position.

3. Place hand throttle to idle position.

4. Disengage PTO.

5. Place SCV levers in neutral position.

6. Lower hitch completely if an implement is attached.

7. Turn key switch to the run position. DO NOT start engine.

8. Wait until light check sequence is complete.

9. Check for any indicator lights or trouble codes that impair machine performance. If necessary, have John Deere dealer diagnose the problem.

10. Depress clutch and brake pedals.

11. Sound horn.

12. Turn key switch to engage the starter. Release key when engine starts.

IMPORTANT: Avoid starter damage. Do not operate the starter more than 30 seconds. Wait at least two minutes before trying again.

If Engine Fails To Start:

• Place hand throttle lever at 1/4 to 1/3 of full throttle and attempt to start machine again.
• In cold weather (at or below 5°C (41°F)), see “Cold Weather Starting” procedure in this section.
• Check for trouble codes or electrical problems.
• If engine fails to start after three attempts, see your John Deere dealer.

NOTE: In cold weather, engine speed is limited to 1440 rpm until transmission-hydraulic oil temperature is above -18°C (0°F).