Maintenance Interval Chart

Activity	As Required	First 10 hrs	10 hrs	First 50 hrs	50 hrs	First 100 hrs	250 hrs	500 hrs	1000 hrs	1200 hrs	2000 hrs
Checking and adjusting hand brake lever.	•
Bleeding fuel system.	•
Clean primary air filter element.	•1
Cleaning grille screens, radiator, oil cooler or A/C condenser.	•
Adjust 540E PTO throttle limiter — SS.	•
Adjust 540E PTO throttle limiter — SS.	•
Adjust 540E PTO without throttle limiter —SS.	•
Warming hydraulic system oil.	•
Check selective control valve.	•
Servicing air conditioner (Cab).	•
Adjust throttle friction.	•
Keep cab protection system installed properly.		•			•
Tighten wheel hardware.		•		•
Check engine oil level.			•
Check coolant level.			•
Check fuel system water separator.			•
Drain water and sediment from fuel tank.			•
Checking tires.			•
Inspect ROPS for loose hardware.	•			•
Check and adjust clutch pedal free pay.					•
Adjust PTO clutch operating rod.					•2
Check transmission-hydraulic system oil level.					•
Lubricate MFWD axle.					•
Lubricate 2WD front axle — high clearance.					•3		•4
Lubricate 2WD Front Axle					•3		•4
Lubricate 3-point hitch.					•
Inspect all tires.					•
Change engine oil and filter.						•	•5
Check front loader mounting bracket installation cap screws tensions.						•	•
Replacing fuel filter — OOS.							•
Clean and check battery.							•6
Check neutral start system — mechanical PTO.							•
Check planetary drive oil level.							•
Check MFWD axle oil level.							•
Inspect tractor for loose hardware.							•
Cleaning cab air filters.							•
Inspecting and replacing alternator/fan belt.						•		•
Replacing fuel filter — Cab.								•
Cleaning water separator.								•
Replace primary fuel filter.								•
Checking air restriction indicator performance.								•
Checking neutral start system — EH PTO.								•
Lubricate rear axle bearings.								•
Lubricate front axle wheel bearings — 2WD.								•7
Change planetary drive oil.						•			•
Change MFWD axle oil.						•			•
Check hoses and hose clamps.									•
Clean engine crankcase vent tube.									•
Replace primary and secondary air filter elements.									•8
Check unloader valve condition.									•
Change transmission-hydraulic oil and filter.									•
Clean transmission hydraulic pickup screen.									•
Check front axle end play — 2WD.									•
Adjust rockshaft.									•
Pack front wheel bearings (adjustable front axle).									•9
Change high crop rear axle oil.										•
Adjust engine valve clearance and fuel injectors.											•
Check engine idle speeds.											•
Flush cooling system and replace thermostat.											•10
Replacing thermostat.											•