Adjust Engine Speed Control Linkage (S.N. 830205- )

1. Move speed control lever to fast idle position.

2. Measure injection pump lever override (C). Fast idle override is measured from the front edge of the short lever (B) to the front edge of the long lever (A). Override must be to specification.

Specification

Injection Pump Lever (Fast Idle) -Override 3-6 mm (0.12-0.24 in.)

3. Adjust swivel on speed control rod to provide override.

4. Move speed control lever to slow idle position and check override. Slow idle override is measured from the rear edge of the short lever to the rear edge of the long lever. Override must be to specification,

Specification

Injection Pump Lever (Slow Idle) -Override 0.5 mm (0.02 in.) minimum

5. Measure at fast idle again for a minimum of 3 mm (0.12 in.) override.

6. Open access door on reservoir cowling to adjust foot control pedal.

T118064B
T119995

Slow Idle Position Shown


A-Long Lever
B-Short Lever
C-Injection Pump Lever Override

CED,OUO1032,1198 -19-07JAN99-1/2

7. Disconnect swivel (A) from rod (B). Adjust vertical rod (C) length to allow foot control pedal to stop on floor with hand lever in the extreme forward position.


A-Swivel
B-Rod (Speed Control Pedal)
C-Vertical Rod

T119969B

CED,OUO1032,1198 -19-07JAN99-2/2