OMT164842 B9: 710D Backhoe Loader, Block File: TX_25_BD2079_19

Using Booster Batteries-12 Volt System

Single Battery Application

Two Battery Application

A-Machine Battery(s)

B-Booster Battery(s)

Before boost starting, machine must be properly shut down and secured to prevent unexpected machine movement when engine starts.

causym CAUTION: An explosive gas is produced while batteries are in use or being charged. Keep flames or sparks away from the battery area. Make sure the batteries are charged in a well ventilated area.

Always remove grounded (-) battery clamp first and replace it last.

IMPORTANT: The machine electrical system is a 12-volt negative (-) ground. Use only 12-volt booster batteries.

1. Connect one end of the positive cable to the positive terminal of the machine batteries and the other end to the positive terminal of the booster batteries.

2. Connect one end of the negative cable to the negative terminal of the booster batteries. Then connect other end of the negative cable to the machine frame as far away from the machine batteries as possible.

3. Start engine.

TX,25,BD2079 -19-07OCT96-1/2

4. Immediately after starting engine, disconnect end of the negative cable from the machine frame and disconnect the other end of the negative cable from the negative terminal of the booster batteries.

5. Disconnect positive cable from booster batteries and machine batteries.

TX,25,BD2079 -19-07OCT96-2/2