Changing Loader Buckets

CAUTION: Prevent possible injury from falling hardware. Bucket cylinder and links will fall forward when bucket is flat on floor and pins are removed. Remove pins only when bucket is on floor in full dump position.

1. Place bucket in dump position on floor.

2. Remove pin (E) and lay bucket links (D) on cross tube.

3. Remove pin (C) and carefully lay cylinder (A) on cross tube.

4. Remove pins (B). Repair or replace bucket as needed.

5. Install pins (B).

6. Connect bucket links and cylinder.

7. Install pins (E and C).

A-Cylinder
B-Boom-to-Bucket Pin (2 used)
C-Cylinder-to-Bucket Pin
D-Bucket Link (2 used)
E-Bucket Link-to-Bucket Pin

TX,35,RR2576 -19-15MAR93-1/1