Maintenance and Repair Record Keeping System

BREAK-IN SERVICE INTERVALS
Break-in service is required for your machine at intervals shown in chapter 15. Refer to chapter 15 during the first 100 hours of machine operation. After 100 hours refer to service intervals in chapter 50.
SERVICE INTERVALS AFTER BREAK-IN
Service your machine at intervals shown on this chart. Also, perform service on items at multiples of the original requirement. For example, at 500 hours also service those items (if applicable) listed under 250 hours, 100 hours, 50 hours, and 10 hours or daily.
As Required
· Check and clean precleaner · Adjust boom lock
· Check and clean cab fresh air filter · Check and adjust park brake (S.N. -872256)
· Check tire pressure · Grease extendible dipperstick extension
· Check and adjust belt tension (S.N. -830204) · Grease extendible dipperstick housing wear surfaces
· Check belt tension (S.N. 830205- ) · Grease non-powered front wheel bearings
· Drain fuel tank sump  
Every 10 Hours or Daily
· Check radiator coolant level at recovery tank · Grease backhoe pivot points
· Check engine oil level · Grease backhoe pivot and cylinder rod end
· Grease loader pivots points · Grease front axle and steering cylinder pivots
· Grease MFWD driveshafts U-joints-if equipped · Grease MFWD front axle U-joints-if equipped
· Grease stabilizer and pivots  

 

TX,50,BG716 -19-15FEB97-1/4


REQUIRED PARTS
Insure machine performance and availability; use only genuine John Deere parts. Verify part numbers are current and that any associated parts are also on hand, i.e., filters, O-rings.
  Part Number ASI 250 Hours 500 Hours 1000 Hours 2000 Hours
Engine Oil Filter (S.N. -830204) T19044 1 1 1 1 1
Engine Oil Filter (S.N. 830205- ) RE59754 1 1 1 1 1
Fuel Filter RE62419     1 1 1
Hydraulic Reservoir Breather AT101565     1 1 1
Hydraulic Oil Filter AT140315     1 1 1
Transmission Oil Filter (S.N. -872256) AT67960       1 1
Transmission Oil Filter (S.N. 872257- ) AT179323       1 1
Engine Rocker Arm Cover Gasket (S.N. -830204) R75728       1 1
Engine Rocker Arm Cover Gasket (S.N. 830205- ) R123543         1
Cab Heater Filter AT141209 As Needed
Air Cleaner Element (Primary) AT39124       1 1
Air Cleaner Element (Secondary) AT31227       1 1
Cab Fresh Air Filter AT141209 As Needed
Brake System Filter (S.N. 872257- ) AT183869       1 1
TORQ-GARD SUPREME® PLUS 50™ Oil TY6392 19 L (20 qt) 19 L (20 qt) 19 L (20 qt) 19 L (20 qt) 19 L (20 qt)
HY-GARD® Transmission and Hydraulic Oil TY6354  
  without MFWD (S.N. -872256)   53.2 L (14 gal) 53.2 L (14 gal)
  with MFWD (S.N. -872256)   65.5 L (17.3 gal) 65.5 L (17.3 gal)
  without MFWD (S.N. 872257- )   55 L (14.5 gal) 55 L (14.5 gal)
  with MFWD (S.N. 872257- )   67.3 L (18 gal) 67.3 L (18 gal)
  Rear Axle (S.N. -872256)   18 L (4.75 gal) 18 L (4.75 gal)
  Rear Axle (S.N. 872257- )   16 L (4.25 gal) 16 L (4.25 gal)
API GL-5 Gear Oil   13.3 L (14 qt) 13.3 L (14 qt)
OILSCAN® PLUS KITS:
Diesel Engine Oil AT178840   1 1 1 1
Transmission Oil AT178840       1 1

 

TORQ-GARD is a registered trademark of Deere & Company.
PLUS 50 is a trademark of Deere & Company
HY-GARD is a registered trademark of Deere & Company.
OILSCAN is a registered trademark of Deere & Company.

TX,50,BG716 -19-15FEB97-2/4


Hydraulic Oil AT178844       1 1
Coolant Conditioner RY16004 As Needed

 

MAINTENANCE AND REPAIR RECORD KEEPING SYSTEM
Model: [ ] 710D Customer:
PIN/Serial Number: Delivery Date: Hour Meter Reading:
OIL SAMPLING
Oil samples should be taken from each system prior to its recommended drain or change interval indicated on this form: 250, 500, 1000 hours. Maintenance recommendations supplied by OILSCAN will be provided based upon the oil analysis and operating information you supply. Regular oil sampling will extend the operational life of your machine's systems.
Every 250 Hours
[ ] Drain and refill engine oil [ ] Check transmission oil level
[ ] Replace engine oil filter [ ] Check battery electrolyte level and clean terminals
[ ] Check hydraulic reservoir oil level [ ] Check MFWD front axle housing oil level
[ ] Check rear axle oil level [ ] Check MFWD planetary housing oil level
Comments:
 
Date: Hour Meter Reading:
Maintenance Performed By:
Every 500 Hours
[ ] Check coolant conditioner to radiator [ ] Check air intake hoses
[ ] Replace fuel filter [ ] Replace hydraulic oil breather filter
[ ] Replace hydraulic oil filter [ ] Check accumulator action
Comments:
 
Date: Hour Meter Reading:
Maintenance Performed By:

 

TX,50,BG716 -19-15FEB97-3/4


MAINTENANCE AND REPAIR RECORD KEEPING SYSTEM
Every 1000 Hours
[ ] Clean engine crankcase vent tube [ ] Check non-powered front wheel bearings
[ ] Check engine speed linkage [ ] Replace MFWD front axle housing oil-if equipped
[ ] Replace transmission sump oil and filter [ ] Replace MFWD planetary housing oil-if equipped
[ ] Replace hydraulic reservoir oil and filter [ ] Replace engine air filter elements
[ ] Replace rear axle oil [ ] Replace brake system filter
Comments:
 
Date: Hour Meter Reading:
Maintenance Performed By:
Every 2000 Hours
[ ] Adjust engine valve lash (S.N. 830205- )  
Comments:
 
Date: Hour Meter Reading:
Maintenance Performed By:

 

TX,50,BG716 -19-15FEB97-4/4