Check Coolant Conditioner in Radiator

CAUTION: Prevent possible injury from hot spraying water. DO NOT remove radiator cap unless the engine is cool. Then turn cap slowly to the stop. Release all pressure before removing cap.

1. Turn cap (A) slowly to the stop to release pressure. Then remove cap.

2. Add TY16004 John Deere Coolant Conditioner or equivalent non-chromate conditioner/rust inhibitor, following instructions on container. Drain enough coolant from radiator to allow room for the conditioner.

Specification

NOTE: Add conditioner every 500 hours or 6 months, or if you replace 1/3 or more of coolant.

John Deere Liquid Coolant Conditioner does not protect against freezing.

DO NOT add John Deere liquid coolant conditioner to a cooling system already equipped with an operational filter conditioner system. Too much conditioner in a cooling system may cause silicate-dropout. When this happens, a gel-type deposit is created which can restrict coolant passages in the radiator and engine, resulting in engine overheating.

TX,80,BG580 -19-17DEC98-1/1