Changing Reverse Warning Alarm Volume

IMPORTANT: The reverse warning alarm is set on high volume at the factory. It may be necessary to adjust the volume to meet local regulations.

1. To change alarm to low volume, remove nut (A) and disconnect wire from "POS HI" terminal.

2. Remove nut (C) and shorting bar (B).

3. Attach wire to "POS LOW" terminal (D). Install nut and tighten securely. Save shorting bar for future use.


A-Nut
B-Shorting Bar
C-Nut
D-Terminal

T7673AI
T7673AH

TX,90,RR2621 -19-24AUG94-1/1