Installing Teeth on Heavy Duty Backhoe Bucket

1. Position flex pin half with grooves (D) toward the tooth tip. The grooves are the locking mechanism.

NOTE: If "back" is stamped on the pin, this word must face the shank.

If shank is badly worn, install new shank.

Install special teeth for digging in rock or frost.

2. To remove tooth tip (A), drive out flex pin (C).

3. To fasten tooth tip to shank (B), drive flex pin (C) in place.


A-Tooth Tip
B-Tooth Shank
C-Flex Pin
D-Grooves

T7646AP
T7646AO
T7646AN

TX,90,RR,2104 -19-09DEC93-1/1