| Model: [ ] 410G |
Customer:
|
PIN/Serial Number:
|
Delivery Date:
|
Hour Meter Reading:
|
| OIL SAMPLING |
Oil samples should be taken from each system prior to its recommended drain or change interval indicated on this form: 250, 500, 1000 hours. Maintenance recommendations supplied by OILSCAN PLUS will be provided based upon the oil analysis and operating information you supply. Regular oil sampling will extend the operational life of your machine's systems.
|
| Every 250 Hours |
| [ ] Check MFWD front axle housing oil level (if equipped) |
[ ] Drain and refill engine oil and replace engine oil filter |
| [ ] Check battery electrolyte level and terminals |
[ ] Check transmission oil level |
| [ ] Check rear axle oil level |
[ ] Check MFWD planetary housing oil level (if equipped) |
| [ ] Check hydraulic reservoir oil level |
|
Comments:
|
|
Date:
|
Hour Meter Reading:
|
Maintenance Performed By:
|
| Every 500 Hours |
| [ ] Check air intake hose |
[ ] Replace hydraulic reservoir breather |
| [ ] Replace hydraulic system oil filter |
[ ] Replace fuel filter |
[ ] Check boom-to-dipperstick pivot pin bolt torque
|
[ ] Check coolant conditioner |
| |
|
Comments:
|
|
Date:
|
Hour Meter Reading:
|
Maintenance Performed By:
|
| Every 1000 Hours |
| [ ] Drain and refill MFWD front axle housing oil (if equipped) |
[ ] Drain and refill hydraulic reservoir oil |
| [ ] Clean, pack, and adjust non-power front wheel bearings (if equipped) |
[ ] Clean engine crankcase vent tube |
| [ ] Check and adjust engine speed control linkage |
[ ] Drain and refill transmission and torque converter oil |
| [ ] Drain and refill rear axle oil |
[ ] Drain and refill MFWD planetary housing oil (if equipped) |
| [ ] Replace transmission oil filter |
[ ] Replace engine air filter elements |
| |
|
Comments:
|
|
Date:
|
Hour Meter Reading:
|
Maintenance Performed By:
|
| Every 2000 Hours |
| [ ] Adjust engine valve lash |
|
Comments:
|
|
Date:
|
Hour Meter Reading:
|
Maintenance Performed By:
|